Project details
Skill
成本
Estimated Time
Paint expert Mauro Henrique teaches Kevin O’Connor how to patch scratches and chips in porcelain. While it is a tough material, Mauro explains that these types of damage are extremely common, and he teaches Kevin how to handle them.
Porcelain is a durable material, but it’s relatively soft as far as tiles go. This means it’s susceptible to cracks or chips, and they’re often eyesores. Luckily, it’s possible to hide the damage with a bit of touch-up glaze. Here’s how tofix cracked and chipped tiles.
How To Fix Cracked and Chipped Porcelain Tile
- Lightly sand the damaged area with 120-grit sandpaper to knock down any sharp edges. A light sanding should be all it takes.
- Use painter’s tape to mask off the rest of the porcelain surface around the damaged area. Porcelain patching glazed and epoxies can run so it’s best to protect the surrounding area.
- For a crack or a scratch, use the touch-up glaze to fill in the damage. In most cases, the bottle of glaze will have a paintbrush built into the cap. If not, use an artist’s paintbrush to apply the touch-up glaze. Give the touch-up space 30 to 35 minutes to dry before applying more glaze. For chips, use a putty knife to apply spot epoxy to the damaged area. Use thin coats but cover the entire chipped area. Give the damaged area about 45 minutes to dry before sanding and applying another coat, if necessary.
- The repaired areas will have a slightly glossy finish. If the damaged tile has a matte finish, it will be necessary to lightly sand the patch until the finish matches the rest of the tile.
- Give the repairs 24 hours to dry entirely and 5 days before cleaning with any detergents or solutions.
Resources
毛罗(Mauro)展示了凯文(Kevin)的方式,房主可HomeHome以修补小瓷刮擦和碎屑。
To fix the scratch, Mauro preps the porcelain tile by washing and drying the scratched surface using丙酮和rag. After the surface is dry, Mauro tapes off the damaged area withpainter’s tape.
Using aporcelain touch-up glaze, Mauro mixes thoroughly and applies it using an applicator brush.
After it dries fully, Mauro uses120-grit sandpaperto smooth the surface. Mauro says to allow the glaze 24 hours to dry.
To fix the chip, Mauro sands the chipped area with400-grit sandpaper. After sanding, Mauro cleans off the surface with acetone and a rag. Mauro then tapes off the chipped area with painter’s tape. Using aspot epoxy, Mauro applies a small amount to aputty knife和gently applies it to the chipped area. Mauro says to allow the epoxy to dry for 24hrs and 5 days before cleaning.